Troubleshooting - THOMSON THPRIMO245DFULL Manuel D'utilisation

Frost precaution
Please take frost protection measures on the dishwasher in winter. Every time after washing cycles,
please operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve (Use a pan to gather the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the door slightly open so that
moisture and odors are not trapped inside.
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning
products. Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the interior, use a cloth dampened with water an a little
vinegar, or a cleaning product made specifically for dishwashers.
When not in use for a long time
It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug from
the mains socket, turn off the water supply and leave the door of the appliance slightly open. This will
help the door seals to last longer and prevent odors from forming within the appliance.
Moving the appliance
If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be
positioned on its back.
Cleaning the seals
One of the factors that cause odours to form in the dishwasher is food that remains trapped in the seals.
Periodic cleaning with a damp sponge will prevent this from occurring.

TROUBLESHOOTING

Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
Problem Possible Causes
Fuse blown, or the ircuit
breaker tripped
Dishwasher
Power supply is not turned
will not start.
on.
The door has not been
properly closed.
Kink in drain hose
Water not
pumped from
Filter clogged
dishwasher
Possible Solution
Replace fuse or reset circuit breaker.
Remove any other appliance sharing the same
circuit with the dishwasher.
Make sure the dishwasher is turned on and the
door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Close the door securely.
Check drain hose.
Check the filters (see Cleaning the Filtering
System ).
GB-25