Cleaning And Maintenance - THOMSON THPRIMO245DFULL Manuel D'utilisation

6. Add the required amount of detergent into the dispenser according to the Washing Program chart.
7. Press to switch on the dishwasher.
8. Repeatedly press
 The display will show the number of the program you have chosen.
 To select the self-cleaning program, press and hold
same time for about 3 seconds until the display shows CLn .
 Delay Timer:
The delay timer allows you to delay the start of a washing program from 1 hour up to 24 hours.
Repeatedly press
9. Repeatedly press
cycle.
 The corresponding indicator light (s) will illuminate on the display.
10. Close the door and the dishwasher will start the cycle.
11. After the program has ended, the diswasher will buzz and stop.

WARNING!
 The washing cycle will not start if the dishwasher door is left open or not properly closed.
 Do not open the door when the dishwasher is working since hot water may be ejected, which could
cause scalding.
Adding extra dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow
the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. The cycle will start from the point at which it was interrupted.
Changing the program in progress
A wash cycle can only be changed if it has been running for a short time otherwise, the detergent may
have already been released and the dishwasher may have already drained the wash water. If this is the
case, the dishwasher needs to be reset and the detergent dispenser must be refilled. To reset the
dishwasher, follow the instructions below:
1. Open the door a little to stop the washing. After the spray arms stop working, you can open the door
completely.
2. Press and hold for more than 3 seconds the program will cancel. You will hear a beep.
3. Repeateldy press
 The new number of the selected program will illuminate.
4. Close the door to start the program.

CLEANING AND MAINTENANCE

 Always switch off and unplug the appliance before cleaning.
 To avoid penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind.
to select the desired washing program.
until the desired delayed start time indicator light illuminates.
to select the upper, lower or both baskets to be sprayed during a washing
to select a new program.
and
55-65 C
6 C 5
GB-22
at the
35 C
55 C