Using The Rinse And Detergent Dispensers - THOMSON THPRIMO245DFULL Manuel D'utilisation

will be immediately removed by the water; the prolonged presence of salt water inside the tank may
lead to corrosion.
Adjusting the salt consumption
1. Open the door and switch on the appliance.
2. Enter the status of adjusting the salt consumption by holding down
3. Repeatedly press
4. Press to validate settings.
WATER HARDNESS
dH fH
0 5 0 9
6 11 10 20
12 17 21 30
18 22 31 40
23 34 41 60
35 55 61 98
Factory setting: H3
NOTE:
1 dH=1.25 Clarke= 1.78 fH= 0.178 mmol/l
dH: German degree
Filling with salt
The salt container must be refilled when the salt warning light
1. Remove the lower basket and unscrew the cap from the salt container.
2. Place the end of the funnel (supplied) into the hole and pour in about 1.5kg dishwasher salt.
3. Fill the salt container to its maximum limit with water.
It is normal for small amount of water to come out of the salt container.
4. Screw back the cap tightly.
NOTE: Depending on how well the salt dissolves, the salt warning light
the salt container is filled.

USING THE RINSE AND DETERGENT DISPENSERS

Function of the rinse aid
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes,
which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes.
WARNING! Only use branded rinse aid for dishwasher. Never fill the rinse aid dispenser with any other
substances (e.g. Dishwasher cleaning agent, liquid detergent). This would damage the appliance.
to adjust the setting to suit the water hardness.
Clarke Mmol/l
0 6 0 0.94
7 14 1.0 2.0
15 21 2.1 3.0
22 28 3.1 4.0
29 42 4.1 6.0
43 69 6.1 9.8
fH: French degree
Display
H1
H2
H3
H4
H5
H6
Clarke: British degree
illuminates.
GB-17
until the display shows H3.
Salt consumption
(gram / cycle)
0
9
12
20
30
60
may still be on even though