GE RAK149P2 Manuel Du Propriétaire Et Instructions D'installation page 12

Testing the thermostat
Heat Test
1. Slide Function switch to Heat
position. Heat mode screen is
displayed.
2. Adjust set temperature so it is
5 degrees above room temperature.
3. Heat should come on within a few seconds.
4. Adjust the set temperature so it is 2 degrees below
the room temperature and the heat should turn off.
Note: There is a 3 minute time delay and a 3 minute
minimum run time for the compressor when it turns
on/off. (On some models, the fan may also have a
minimum run time/off time delay).
12
HEAT
:
PM
49-5000517 Rev. 3