Uberhaus GJC10CI-A3RNA5A Guide De L'utilisateur page 12

16. Slide inner window sash firmly against side
of the cabinet. Make sure not to peel the seal strips
from the window track and cabinet side channels. If
the panel frame does not fit snugly to the inner
window sash, secure the panel frame to the sash
with #8x3/4-inch screws, or #8-32x3/4-inch self-
threading screws. Use the partially plugged holes in
the panel frame. Drill 1/8-inch pilot holes for the
screws.
17. Hook the safety bracket over the base of the
unit and fasten it to the front of the platform
assembly. Use a #8-32x3/4-inch self-threading
screw.
NOTE:
The bracket prevents movement of the
air conditioner (either in or out) after completing the
installation.
18. Stuff the foam seal strip/sash seal between
the vertical sash and the window glass, as shown
right.
19. Use the window locking bracket to lock the
inner window sash to the base of the outer window
sash. Use one #8x3/4-inch screw, or #8-32x3/4-
inch self-threading screw. (Drill 1/8-inch pilot hole).
20. To replace the front
First reconnect the coupler plugs, then position the
exhaust control through the front in the proper
location. Gently push the front into position on the
cabinet. It should click into place. Then replace the
retaining screws that holds the panel in place.
Do not push or pull the front panel louvers.
Alternate Window Jamb
Applications
To install your air conditioner in windows having no
flanges or wood stops on the top and side jambs, the
channels and panel frame must fit against a mating
flange (or 1/16-inch max. thick angle) attached to the
window jambs. Figure A shows this angle installed.
Figures B & C show alternate treatments. On the sash
side of the opening, the leading corner of the inner sash
becomes the flange. You can purchase the angle
strip at your local hardware store.
Installation Instructions
11
Slide inner
window sash
firmly against
Cabinet.
Install safety bracket
Safety bracket
Sash seal
Window
locking
bracket
Room
A
Add angle to
wood stop
Flush
Room Room
C
B
Add 16- or 18-
Add wood
gauge angle
as shown