Uberhaus GJC10CI-A3RNA5A Guide De L'utilisateur page 10

4. Peel off protective backing from track seal. Apply
seal to room side of window track. Center of seal strip
should be aligned with the line marked in Step 2. Those
two screw holes drilled in Step 3 should be directly
above seal strip in the inner track.
5. Securely attach a siding-protection board to
side of house.
NOTE:
Siding-protection board should be long
enough to span 2 wall studs.
6. Place platform assembly, with platform tab
against inside of window track, and attach it to
window jamb. Use appropriate length screws (Items
9-11 in Preparing For Installation).
7. Adjust platform assembly so that outside edge is
3/16-inch lower than inside edge, as shown on the right.
This ensures proper water drainage from the air
conditioner.
8. Level platform assembly from side-to-side.
Also, make sure window track is level. Use leveling
shims as necessary to ensure unit is level from side-
to-side.
9. Measure height of window opening from top of
platform assembly as shown right. Subtract 20-5/8
inches. Mark this measurement on plastic window
panel, along the longer side. (continued)
Installation Instructions
Inside
wall of
house
Put platform
tab against
inside of
track.
Measure
distance and
subtract
20 / inches. 5
8
9
Apply track seal
to window side
of track.
Siding-protection
board
Outside edge is 3/16-inch
lower than inside.