Child Safety; Wifi Configuration - Hoover HOA03 WIFI Notice D'emploi Et D'installation

6. CHILD SAFETY

This function is essential, especially when children are around. It
prevents children from switching the oven on or altering the preset
programmes.
This safety system locks the oven control panel while it is operating.
There are two levels of safety :
LEVEL 1 : Locking selector control knob and the central button.
•To activate : Turn the programmation control knob to child safety.
•Action : The control knobs are inactive*.
•To deactivate : Turn the programmation control knob to 0.
LEVEL 2 : Locking function selector knobs
•To activate : Turn the function selector knob to child safety and keep
the central button pressed in for 3 seconds.
•Action : All the controls are inactive*.
•To dactivate : the same procedure as for activating. Turn the function
selector knob to child safety and keep the central button Pressed in for
3 seconds.
*Note : In all cases, for reasons of safety, even when the controls are
locked, the oven can be switched off by turning the selector knob to 0.
7. WIFI FEATURE

WIFI CONFIGURATION

• Turn the oven selector knob to the WiFi position (the "@" symbol
flashes).
• When the oven is connected to a wireless router and the WiFi
function is selected the "@'" symbol stays on continuously,
• If the oven is not connected to a wireless router the "@" symbol
flashes. (see section on "@" symbol management).
• If the Wifi function is selected, the oven can only be remotely
controlled (function selector and encoder are disabled);
• In the other cooking positions the oven cannot be externally
controlled.
RESET
To reset the WiFi , turn the oven selector knob to the WifI position while
no program is running and push the encoder for 3 seconds.
After 3 seconds, on the display will appear "rSt" and the "@" symbol
starts to flash.
"@" SYMBOL MANAGEMENT
• When the oven is off, the symbol is off;
• When the oven selector knob is in the Wi-Fi position, the symbol
flashes (1" on, and 1" off) if this oven is in "access point" mode
(connected point-to-point), while stays steadily on if the oven is in
"client" mode (connected to a router);
• When the oven selector knob is turned on to the Wi-Fi position and
the oven is trying to connect to a router, the symbol flashes (3 " on, and
1" off);
• When the oven selector knob is turned on but not on Wi-Fi position
(read-only), the symbol flashes (1 "on and 3" off).
HOOVER WIZARD:
For detailed information about HOW TO CONNECT
your Wizard appliance and HOW TO USE it at its best,
go to http://www.hooverwizard.com or visit the
dedicated Wizard Customer Service website
http://wizardservice.candy-hoover.com
10 GB