Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
J
CONNECTIONS
EN
J1
ELECTRICAL CONNECTIONS
WARNING :
- Before installation and maintenance make sure that power supply
to the electric lines has been turned off;
- Use cables with minimum cross-sections, rated voltages and instal-
lation type that are suitable for the characteristics indicated in para-
graph G ELECTRICAL DATA.
- Always close the cover of the terminal strip box before switching
on the power supply, after having checked the integrity of the seal
gaskets that ensure the IP55 protection grade.
ELECTRICAL
• Cables with faston connector coupling for connection to the power
supply line;
FITTINGS
• RED cable: positive pole (+)
• BLACK cable: negative pole (-)
• Terminal strip box (protection class IP55 in conformance with the
directive EN 60034-5-97) complete of:
-ON/OFF switch;
-Safety fuse against short circuits and overcurrent, featuring the fol-
lowing characteristics:
25A for 12V models
15A for 24V models
• power cable complete of pincers for connection to the battery
MOTOR CABLE
CAVI MOTORE
INTERRUTTORE
10
ELECTRIC SHIOCK HAZARD
It is the responsibility of the installer to carry out the
electrical connections in compliance with the applicable
regulations.
Comply with the following (not exhaustive) instructions to
ensure a proper electrical connection:
FUSE
FUSIBILE
RED
ROSSO
RED
ROSSO
+ _
BLACK
NERO
BLACK
NERO
SWITCH
ELECTRICAL BOX
SCATOLA
MORSETTIERA
_
+
M0309
Publicité
Table des Matières
