Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Horizontal and vertical installation possible
horizontal
To prevent
The installation of the flow
meter in long pipes without
support has to be pre-
vented.
Partially filled pipes lead to
major
and thus have to be pre-
vented.
Large starting gaps be-
tween pipe and flow meter
can lead to high torsional
and flexional stresses at
the device when nuts are
tightened.
A sideways installation an-
gle of ± 15° for sensor head
has to be avoided. Air bub-
bles or dirt accumulations
might interfere with the
measurement in case of
sensor contact.
24
vertical
measuring
errors
Recommendation
In plants with long pipes di-
rectly connected to the de-
vice vibration damping con-
nection pieces should be
used.
During operation the pipe al-
ways has to be filled com-
pletely.
The gaps for seals need to
be as small as possible so
that
the
device
stressed during tightening
the nuts.
The installation like shown
on the picture is ideal.
is
not
Publicité
Table des Matières
