Memory Functions - Bosch PLR 30 Instructions D'emploi

All manuals and user guides at all-guides.com
OBJ_BUCH-145-003.book Page 21 Wednesday, June 6, 2007 9:02 AM
Continuous Measurement (Tracking) (see figure B)
The continuous measurement function (tracking) is used for the transfer-
ring of measurements, e.g., from construction plans. In continuous meas-
urement mode, the measuring tool can be moved relative to the target,
whereby the measured value is updated approx. every 0.5 seconds. As an
example, the user can move from a wall to the required distance, while the
actual distance can be read continuously.
For continuous measurements, push button 11. The indicator for continu-
ous measurement (tracking) appears in the display
Press the measuring button 8 to initiate the measur-
ing procedure. Move the measuring tool until the
required distance value is indicated at the bottom of
the display.
Pushing the measuring button 8 interrupts the contin-
uous measurement. The current measured value is in-
dicated in the display. Repeated pushing of the meas-
uring button 8 starts the continuous measuring again.
The continuous measurement automatically switches off after 5 minutes.
The last measured value remains indicated on the display. The continuous
measuring can also be ended by pushing the buttons 4, 5 or 9 which
changes the measuring function.
Deleting Measured Values
Pushing the delete button 1 deletes the last individual measuring value
determined in all measuring functions. Pushing the button repeatedly
deletes the individual measured values in reverse order.

Memory Functions

When switching off the measuring tool, the value in the memory is retained.
Storing/Adding Measured Values
Push the memory add button 3 in order to store the
current measured value – a length, area or volume
value, depending on the current measuring function.
As soon as a value has been stored, "M" is indi-
cated in the display and the "+" behind it briefly
flashes.
If a value is already stored in the memory, the new value is added to the
memory contents, however, only when the measures of unit correspond.
As an example, when an area value is in the memory and the current meas-
ured value is a volume value, the addition cannot take place. "ERROR"
briefly flashes in the display.
Subtracting Measured Values
Push the memory subtraction button 2 in order to subtract the current
measured value from the memory value. As soon as a value has been sub-
tracted, "M" is indicated in the display and the "–" behind it briefly flashes.
If a value is already stored in the memory, the new measured value can be
subtracted only when the measures of unit correspond (see "Storing/Add-
ing Measured Values").
1 609 929 J82 • 6.6.07
.
English | 21