Install The Side Panels - Kohler Sterling 2200A Serie Guide D'installation

4. Install the Side Panels

Carefully lift the side panel onto the shower base ledge and align the expander jamb of the side
panel over the wall jamb.
NOTE: Perform the procedures below from inside the shower.
Insert the tip of a Phillips screwdriver into the adjustment block hole and turn the top adjustment
block counterclockwise until the adjustment block firmly contacts the wall frame.
Remove the Phillips screwdriver from the adjustment block hole.
Install a #8 x 3-1/2" screw into the adjustment block hole.
Repeat the steps above for the bottom adjustment block.
Repeat the procedure for the other side panel.
Verify the side panels are resting firmly against the shower base ledge.
1034045-2-C
Adjustment
Block Hole
Adjustment
Block
Wall Jamb
Adjustment
Block
Shower
Adjustment
Block Hole
Expander
Jamb Side
#8 x 3-1/2" Screw
Column
Side
6 Sterling