Install The Door Panel - Kohler Sterling 2200A Serie Guide D'installation

12. Install the Door Panel

Lift the door panel and insert the pivot hole of the door side frame over the bottom pivot pin.
Align the top pivot hole of the door side frame with the top bushing.
Insert the long end of the pivot pin through the bushing into the pivot hole of the door side frame.
Confirm that the door is square to the framework opening or to the bottom door seal.
Confirm that the door does not rub on the bottom bridge member.
If the door is not square or rubs, perform the adjustment steps below.
Making Adjustments
NOTE: Do not remove the door or framework, as adjustments can be made with them in place.
From inside the shower, remove the four wall mounting screws.
Make adjustments to the framework by inserting a Phillips screwdriver through the holes in the side
panel expander jamb and turning the adjustment blocks in or out as needed to align the frame.
When adjustments are complete, reinstall the four wall mounting screws.
Sterling
Pivot Pin
Bushing
Bottom Bridge
Member Gasket Strike (Magnet) Side
11
Note:
Do not lift door panel
with Pivot Side Frame.
Pivot Side
Frame
Pivot
Hole
1034045-2-C