Dentsply Sirona
Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect
66 37 487 D3652
D3652.201.01.14.02 10.2017
2. Remove the CEREC Omnicam from its holder.
As soon as the camera is pointed over a tooth or the gums, data
acquisition begins. During the continuous data acquisition, a
color 3D model is generated automatically on the screen.
A white field indicates in which area data will be acquired. If the
automatic data flow breaks off, the white field is lost and the audio
signal changes. In this case, move the camera to any area which
has already been scanned. The scanning procedure continues.
3. Point the cursor to the Omnicam icon in the bottom left corner to end
the acquisition procedure.
Proceeding with scanning procedure
1. Click on the Omnicam symbol with the cursor.
The scanning procedure begins.
2. Proceed with the scanning procedure as described above.
CAUTION
After use, move the camera in its cradle out of the patient environment
to avoid any unforeseen damage to the CEREC Omnicam.
7 Operation
47