Dentsply Sirona CEREC AF Notice D'utilisation page 37

Dentsply Sirona
Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect
66 37 487 D3652
D3652.201.01.14.02 10.2017
WARNING
Hazard for patient and user
If you use a camera for the CEREC AI/AI Connect other than the
supplied CEREC Omnicam, there is a risk of electric shock for patient
and user.
➢ Only use the supplied CEREC Omnicam for CEREC AI/AI Connect.
Do not use a CEREC Omnicam from a CEREC AC/AC Connect or
CEREC AF/AF Connect.
2. Carefully insert the connector of the CEREC Omnicam cable into the
coupling on the shorter of both cables at the camera cradle or the
support arm cable of the CEREC AI/AI Connect, watching out for the
guide nose.
3. CAUTION! Trip/fall hazard! Ensure that the supply cable between the
coupling box and the camera cradle remains fastened at all times so
that the cable cannot pose a trip hazard.
Carefully insert the supply cable connector into the coupling of the
longer of the two cables of the camera cradle (or, for CEREC AI/AI
Connect, into the connection box of the treatment unit to connect to
the supply cable on the camera cradle side), watching out for the
guide nose. Connect the other end of the supply cable to the coupling
box (see image below, connection C).
A LAN connection for PC LAN
cable
B USB connection for USB
2.0 cable
4. Carefully connect the cable stated above (A, B, D).
5. Connect the LAN cable (A) on the PC side with the network connector
labeled with Omnicam.
6. Connect the USB cable (B) to a USB port on the rear of the PC.
7. Plug the power cable of the medical supply unit into the power socket.
6 Installation and startup
C Connection for supply cable (of
the camera cradle)
D 24V connection for medical
power cable
35