Dentsply Sirona CEREC AF Notice D'utilisation page 39

Dentsply Sirona
Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect
66 37 487 D3652
D3652.201.01.14.02 10.2017
Following initial installation
Follow the following steps for proper operation after initial installation.
1. Switch the PC on with the ON/OFF button.
NOTICE
Possible data loss and PC malfunction:
Switching the PC off at the ON/OFF button during operation may cause
data loss and PC malfunctions.
➢ Always switch the unit off as described in the chapter "Switching the
units off [ → 38]".
2. Switch the monitor on.
 When the PC has started up and the coupling box is supplied with
voltage, the illuminated green LED on the camera cradle
indicates that the camera is ready for use. As long as the PC is
switched off, the camera and heater are not supplied with power.
NOTICE
The two USB ports on the front of the PC are also supplied with power,
if necessary, when the PC is switched off (depending on PC hardware
version).
➢ Always connect the coupling box to a USB power on the rear of the
PC.
3. Switch the milling unit on (see the Operating Instructions for the
milling unit).
4. After loading the operating system, start the
application by double-clicking on the
sure that the CEREC Omnicam is already connected when starting
"CEREC SW"
. Subsequent disconnection and re-connection is then
possible without having to restart the
5. For descriptions of further software actions, online help can be
accessed by pressing "F1" or via the Help... menu option.
NOTICE
Internet Explorer V 5.0 or higher must be installed on your system in
order to use the online help function.
Connecting the PC monitor via HDMI
If you have connected your monitor to the PC via HDMI, it may be the
case that the image is surrounded by a black frame. In this case, proceed
as follows to correct it:
1. Right-click on the desktop and select
2. In the window that opens, select
hand side and then select
the sub-menu.
3. In the scaling options, move the slider to the far right to 0% and save
the changes.
6 Installation and startup
"CEREC SW"
"CEREC SW"
"CEREC SW"
"AMD Catalyst Control Center"
"My Digital Flat-Panels"
"Scaling Options (Digital Flat-Panel)"
button. Make
.
.
on the left-
from
37