Control Panel Features - Toshiba RAC-PD0812CRRC Manuel D'utilisation

Control Panel Features

(Press 3s)
(Presse 3s)
Swing Timer
Button Button
Swing Button
Used to initiate the Auto Swing feature. When the
operation is ON, pressing the SWING button can
stop the louver at the desired angle.
Connect Button (Smart models only)
Also used to initiate the wireless connection mode.
To initiate the wireless connection mode, power on
the air conditioner then press the SWING button
for 3 seconds. The LED DISPLAY will show 'AP' to
indicate the unit is in wireless connection mode.
Refer to the app connection instructions to nish
the connection process.
If the connection is successful, the unit will exit
wireless connection mode and illuminate the
wireless LED. If the connection fails, the unit will
exit wireless connection mode automatically after 8
minutes and the wireless LED does not illuminate.
Note: The wireless connection process must be
completed within 8 minutes after powering the air
conditioner on.
Timer button
Used to initiate the AUTO ON start time and AUTO OFF
stop time program, in conjuction with the Up ( )
and Down (
illuminate depending on the selected setting.
Fan button
Controls the fan speed. Press to control the fan speed
in four steps - LOW, MID, HIGH and AUTO. The selected
fan speed light (except AUTO) will illuminate. When
AUTO is selected, no lights will illuminate.
NOTE: In Cool ing or Dry mode, press the Fan button
for 3
function. When the function is turned on, the
constant fan light will illuminate, identifying the fan
continuous run for cooling. When the function is
onstant fan light will go out,
identifying the fan cycle run with compressor stop.
User Manual
Follow Me
Mode Up ( ) and Down ( )
Button Buttons
light will
LED Display
VENT CONSTANT(Presse 3s)
Fan
Button
Mode button
Selects the desired operating mode. Each time you
press the button, a mode is selected in a sequence
that goes from AUTO, COOL, DRY, FAN and HEAT
(cooling only models excluded). The mode light
illuminates and indicates the selected mode.
Up ( ) and Down (
Used to adjust (increasing/decreasing) temperature
settings in 1°C/1°F(or 2°F) increments in a range of
17°C/62°F to 30°C/86°F or the TIMER setting in a range
of 0 ~ 24hrs.
NOTICE
The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the Up and
Down buttons at the same time for 3 seconds.
Power button
Power switch on/o .
Sleep button
Used to initiate the SLEEP operation.
LED display
Shows the set temperature in °C (Degrees
Celsius) or °F (Degrees Fahrenheit) and the
Auto-timer settings. While on DRY and FAN
modes, it shows the room temperature.
Shows Error codes and protection code:
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error
(select models).
E4 - Display panel communication error.
P1 - Bottom tray is full - Connect the drain
hose and drain the collected water
away. If protection code repeats, call
for service.
Connect Indicator Light
(Smart models only)
Sleep Power
Button Button
) buttons
Page 9