Toshiba RAC-PD0812CRRC Manuel D'utilisation page 27

How to Use the Advanced Functions
SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (and don't need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note:
The SLEEP function is not
available in FAN or DRY mode.
SWING Function
Used t o stop or start louver movement and set the
desired up/down air flow direction. The louver
angle changes in 6 degree increments with each
press (not all models). By pressing for more than 2
seconds, the louver auto swing feature is activated.
FOLLOW ME function
The FOLLOW ME function enables the
remote control to measure the temper-
ature at its current location. When using
AUTO, COOL, or HEAT functions,
measuring ambient temperature from
the remote control (instead of from the
indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the unit every
three minutes.
2. Press FOLLOW ME button again to
turn off this function.
NOTES
• Button confi guration shown in illustrations is based on a typical model and may be slightly
diff erent from the actual one you purchased. In this case, the actual physical remote shall prevail.
• All the functions described can also be accomplished by using the unit's control panel. If the
unit is without this feature, there will be no corresponding operation when pressing the relevant
button on the remote controller.
• When there are differences between features or operation implied by the remote control
illustration and the actual functions described in the USER MANUAL, the descriptions in the
USER MANUAL shall prevail.
User Manual
PRESET
MARCHE/
ON
ARRÊTER/
OFF
SHORTCUT Function
Used to restore the current settings or resume
previous settings.
Push this button when remote controller is on,
the system will automatically revert back to the
previous settings including operating mode,
setting temperature, fan speed level and sleep
feature (if activated).
By pressing for more than 2 seconds, the
system will automatically restore the current
operation settings including operating mode,
setting temperature, fan speed level and sleep
feature (if activated).
Page 27