Toshiba RAC-WK0512CMRC Instructions D'installation page 18

7. Install Weather Stripping (ENERGY STAR models only)
If AC is Blocked by Storm Window
Models RAC-WK05/06/08/10/12
Storm window
38 mm min
frame or other
(1-1/2")
obstruction.
Removing AC From Window
• Turn AC off , and disconnect power cord.
• Remove sash seal from between windows, and unscrew safety lock.
• Remove screws installed through frame and frame lock.
• Close (slide) side panels into frame.
• Keeping a fi rm grip on air conditioner, raise sash and carefully remove.
• Be careful not to spill any standing water while lifting unit from window. Store parts WITH air
conditioner.
Page 18
Fig. 14
Fig. 15
SASH
Board thickness
as required, for
proper pitch to rear,
along entire
sill. Fasten with nails
or screws.
In order to minimize air leaks between the
room air conditoner and the window opening,
trim the weather stripping to the proper
length, peel off the protective backing and
plug any gaps if needed (Fig. 14).
Add wood as shown in Fig. 15, or remove
storm window before air conditioner is
installed.
If storm window frame must remain, be sure
the drain holes or slots are not caulked or
painted shut. Accumulated rain water or
condensation must be allowed to drain out.
User Manual