Toshiba RAC-WK0512CMRC Instructions D'installation page 16

" " section
I
Fig. 2
"I" section
Fig. 3
Top Rail
Bottom Rail
Top left
Bottom Rail
4. Secure the Accordion Panels
Measure from the cabinet edge
INSIDE
OUTSIDE
Wooden Windows
Measure from the cabinet edge
INSIDE
OUTSIDE
Vinyl-Clad Windows
Page 16
B. Slide the free end "
cabinet as shown in Fig. 2. Slide the panel down. Be sure to
leave enough space to slip the top and bottom of the frame into
the rails on the cabinet.
C. Once the panel has been installed on the side of the cabinet,
make sure it sits securely inside the frame channel by making
slight adjustments.
Slide the top and bottom ends of the frame into the top and
bottom rails of the cabinet. Fig. 3.
Top Rail
Top right
Fig. 4
H
H:About " to "
5/8 3/4
for 5K)
H:About to 1"
3/4"
for 8K)
3
H:About 1" to 1 /
8"
for 10K to 12K)
H
H:About to 1"
3/4"
for 5K to 8K)
3
H:About 1" to 1 /
8"
for 10K to 12K)
Fig. 5
I
" section of the panel directly into the
D. Slide the panel all the way in and repeat on
the other side.
NOTE
If storm window blocks AC, see Fig. 15.
A. Keep a fi rm grip on the air conditioner, carefully
place the unit into the window opening so the
bottom of the air conditioner frame is against
the window sill (Fig. 5). Carefully close the
window behind the top rail of the unit.
NOTE
Check that air conditioner is tilted back
per dimension H (Fig. 5) (tilted about 3° to
4° downward to the outside). After proper
installation, condensate should not drain
from the overflow drain hole during normal
use. Adjust the slope if otherwise.
User Manual