Starting Up The Appliance - Temptech TCON1 Serie Manuel D'instruction

A -
Temperature and Humidity Controller
B -
LED Light
C - Internal Fan
D -
Door Key (*)
E -
Door Handle
F -
Bottle Shelves
G -
Selection Drawer
H -
Drain and Discharge Hole
I -
Active Charcoal Filter
J -
Adjustable Feet and Wheels
(*) not present in all models
Before starting the appliance, follow the installation
instructions (see "Safety" and "Installation").
This appliance should not be turned on right after
transportation
Two hours is the minimum advised time so that the oil
from the motor-compressor gets back to its original
position.
Installing or moving shelves
Remove any packing materials, check if the racks are
completely inserted and if the shelves are well supported.
If you need to move or add new shelves, please read how
to do so in chapter "Moving or adding shelves".
Checking filter installation
Check if the charcoal filter is aligned and completely
inserted in its position and remove any packing materials.
Checking discharge hole wiper
2)
Drain hole is fitted with a cleaning wiper. Please check if
it is in position.
Install the appliance correctly
This means that the appliance should be installed away
from sources of heat or direct sunlight, in a well
ventilated room.
Shut the door
Open your appliance only when strictly necessary. Every
time you open the door, most of the cold air will be lost.
THE APPLIANCE

STARTING UP THE APPLIANCE

(pag.31 / IMG 2)
(pag.31 / IMG
ENERGY SAVING AND ENVIRONMENT
Starting your appliance
Connect the power cord and wait a few seconds for the
controller to start (the display will show a line of scores).
After start-up, it will show actual internal temperature
and humidity or a dot at the bottom, in this case press the
On/Off key (18) to bring it to ON status.
Set the controller to the desired temperature if different
from default set point 12ºC. See "Controller adjustment".
Loading your bottles
Layout must respect the maximum weight allowable per
shelf. Bottles must not touch the cabinet rear wall nor the
door liner. Weight should be loaded as uniformly as
possible, by spreading the bottles and avoiding
concentration of the load on the top or the bottom of the
appliance.
Sliding shelves should not be loaded with more than two
rows of bottles. Top row should be loaded in such a way
that sliding the shelf forward will not result in bottle
collapse.
Never pull out more than one sliding shelf at a time.
In order to restore the correct temperature, the motor will
have to run and consume energy.
Check the door seal
Keep the seal clean and pliable so that it fits closely
against the door to ensure that no cold air is lost.
Setting temperature and humidity
Observe the recommended ranges, extreme temperature
or humidity set points will increase power consumption.
6