Temptech TCON1 Serie Manuel D'instruction page 10

Make sure the racks have the vibration dampers installed,
put the fixed shelf (J) above the dampers, slide it back so
that it fits and cannot move forward.
Removing a "Selection" drawer
Remove all the bottles from the drawer and the top shelf
(J).
Remove shelf (J) from the drawer racks.
Completely open the drawer and remove the two bottom
screws (K).
Pull the drawer in order to disengage it from the rails.
The LED light does not turn on when
opening the door
Check if:
- The plug has been installed correctly in the electrical
socket and if the distance is adequate;
- There is no electricity in the house.
The wine cellar does not cool well or the
compressor runs constantly
Check if:
- The door does not close properly or if the seal is
damaged;
- The door is frequently being opened;
- The installation conditions are respected.
The appliance makes too much noise
Check if:
- The appliance is levelled;
- The appliance has been installed between cabinets that
vibrate and make noise;
- The installation conditions are respected;
- The internal fan is not obstructed and free to run;
Never call unauthorized technicians and always refuse spare parts that are not originals.
Removing a "Selection" drawer rack
Pull up the front rack until the clip is loose from the side
wall (I), pull the back clip out of the slot in your direction
(H).
Repeat this operation on the other side.
Maximum weight above a shelf
TROUBLESHOOTING
- It is the noise made by the refrigerant, which occurs
even when the compressor is off (this is not a fault).
The internal back wall of the appliance unit
is covered in frost or droplets of water
- This shows that the appliance is operating normally.
There is water in the internal bottom of the
appliance
- The drain hole is not obstructed.
A certain amount of water is normally present in the
drain. This ensures a good humidity control in the
appliance.
If, after checking the above situations, the wine cellar
does not work or the problem persists, please contact the
nearest Service Centre communicating: the type of
malfunction, the appliance model (Mod) and serial
number (SN). This information can be found on the data
plate located inside the appliance.
10
Shelf type
Model 082
Model 150
Model 190
Model 190 side by side
Fixed Sliding Drawer
- 15 kg
86 kg 15 kg 12 kg
95 kg 30 kg 12 kg
95 kg 30 kg 12 kg
-