Temptech TCON1 Serie Manuel D'instruction page 5

type of plug use an A.S.T.A. approved fuse to BS
1362 type and proceed as follows:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important: The fuse cover must be refitted when
changing a fuse and if the fuse cover is lost the plug
must not be used until a correct replacement is fitted.
To ensure that the appliance operates properly and to
reduce energy consumption, it is important that the
appliance is installed correctly.
General conditions
Do not place your appliance in a room liable to flood.
Avoid water splashes in the control panel and in the back
of the appliance.
Ventilation
The compressor and condenser generate heat and need to
be ventilated properly. Rooms with no ventilation are not
suited for the installation of this appliance. Therefore, it
should be installed in a room with an opening (window
or French window) that provides the appropriate amount
of air re-circulation.
For proper ventilation of the appliance, leave a space of
at least 10cm around it and any adjacent cabinets/walls.
Room temperature and humidity
Room temperature should be according to the climate
class of the appliance. Please look at the rating plate
(inside the appliance) to see the climate class of your
wine cellar and compare it with the following ranges:
Symbol Class
SN Extended temperate
N Temperate
ST Subtropical
T Tropical
Extended temperate to
SN-T
tropical
Despite this standard range, your appliance will work
correctly even in a room with temperature starting from
0ºC.
Room relative humidity should be in the range of 50% to
75%. Outside this range the appliance will do his best to
bring internal humidity to set point but, depending on the
load and temperature set point, this cannot be guaranteed.
Correct replacement is identified by the colour insert
or the colour embossed in words on the base of the
plug. Replacement fuse covers are available in your
local electrical store.
INSTALLATION
Away from heat
Avoid positioning the appliance in a place where it is
directly exposed to sunlight, nor near an oven, cook top
or other similar equipments.
Wall Spacer
Before putting the appliance in position, you should
install the supplied wall spacer in the top back of the
appliance. Slightly lose the two screws, slide the space
and then tighten completely.
Levelling the appliance
Your appliance should be installed in a flat, stable and
vibration free surface.
Put your wine cellar in position and then adjust the front
feet (screwing or unscrewing them) in order to bring it to
level. The use of a spirit level is recommended.
Cleaning
Before
compartments and accessories with water and a mild
detergent solution.
Earth electrical connections
Before proceeding with the electrical connection, make
sure that the voltage indicated on the rating plate, located
Ambient range
inside the appliance, corresponds to the mains voltage in
+10 to +32ºC
your home and that the socket is fitted with a standard
+16 to +32ºC
earth wire in accordance with safety standards. If the
+16 to +38ºC
socket is not fitted with an earth wire, the manufacturer
+16 to +43ºC
will not assume liability for any damages and/ or injuries
arising out of the use of the appliance. Do not use
+10 to +43ºC
multiple sockets or adapters.
Position the appliance in such a way that you can access
the socket where it is plugged in.
Insufficient Power
The electrical socket must be able to handle the maximum
power load of the appliance, which is indicated on the
rating plate located inside the wine cellar.
5
(pag.31 / IMG 1)
connecting the power cord, clean the