Before First Use; The Controls - Superia 100 Guide D'installation Et D'utilisation

8. Before first use

When the heating appliance is used for the very first time, it must first dry out completely. For this purpose,
heat it for one hour with a small quantity of fuel.
During this phase, a slight odour may be given off due to the curing of the primer used.
Keep an eye on the appliance during this phase and immediately remove any water formed by
condensation, before it can burn into the enamel or the lacquer.

9. The controls


Operation of the air inlet
- The air supply on the frontside. This is the air-
wash that guarantees you a clean window and
the airsupply for the secondary combustion.
- The air supply on the right back side. This is
the airinlet for the primary combustion. Adapt
this regulation following you're need of heat.
By closing this airinlet you will lower the
heatproduction.

Removing the ash pan before cleaning
- Depending on the quantity of ash, the ash pan
must be emptied regularly – certainly before
the level of the ash reaches the grate. To do
this, hook the pin of the control handle into the
front plate of the ash pan and carefully pull it
out of the appliance so that it can be emptied.
- In case of frequent use (depending on the
quantity of ash) the grids and the space for the
ash tray need to be cleaned thoroughly. This
can be done with a vacuum cleaner when the
appliance has cooled down completely.
- Once per season, the stove should be
removed from the chimney in order to be able
to clean the ashes out of the exhaust pipe
(also with a vacuum cleaner).

Changing the fume outlet duct
If necessary, the fume outlet duct connection (factory setting: on rear), can also be altered to be situated
at the top. Unscrew the top lid and screw it onto the back. Fix the connector pipe (not supplied with this
stove) on top of the stove.
English
Superia 100 / 92 110 219 01
40