Operating Elements And Connections; Applications; Safety Notes - IMG STAGELINE TXS-840 Mode D'emploi

GB All operating elements and connections described
can be found on the fold-out page 3.

1 Operating Elements and Connections

1 Power LED
2 Reception LED
3 Overload LED AF PEAK [independent of the vol-
ume control AUX VOLUME (8)]
4 Power switch
5 Connection SUPPLY 12 V
ply unit (11) [supplied with the receiver]
6 Antennas
7 SQUELCH control for adjusting the threshold for
interference suppression
8 Volume control AUX VOLUME for the output level
of jack AUX (9)
9 6.3 mm output jack AUX for connecting to a micro-
phone input or a highly sensitive line input of a
mixer or amplifier
10 XLR output BAL MIC for connecting a balanced
microphone input of a mixer or amplifier
11 Plug-in power supply unit
12 Low voltage plug of the power supply unit for con-
nection to the jack SUPPLY 12 V
receiver

2 Safety Notes

The units (receiver and power supply unit) correspond
to all required directives of the EU and are therefore
marked with .
WARNING The plug-in power supply unit is sup-
plied with hazard ous mains voltage
(230 V~). Leave servic ing to skilled per-
sonnel only. Inexpert handling may
cause an electric shock hazard.
Always observe the following items:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Even with the receiver switched off, the plug-in
power supply unit connected to the mains supply
has a low current consumption.
G
Do not operate the receiver and immediately discon-
nect the plug-in power supply unit from the mains
socket
1. if there is visible damage to the plug-in power
supply unit or to the receiver,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
6
for plug-in power sup-
(5) of the
3. if malfunctions occur.
In any case the units must be repaired by skilled per-
sonnel.
G
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
G
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected, operated, or not repaired in an
expert way.
If the units are to be put out of operation de -
finitively, take them to a local recycling plant
for a disposal which is not harmful to the envi-
ronment.

3 Applications

In combination with a wireless microphone, the re -
ceiver TXS-8... makes up a wireless microphone sys-
tem. This system allows wireless transmission of
music and speech from the microphone to the re -
ceiver. The range is approx. 30 m and depends on
local condi-tions.
The receiver is available for two different transmis-
sion channels (transmission frequencies) each:
Model Frequency
TXS-840 863,05 MHz
TXS-842 864,80 MHz
* Diversity technique: Two antennas receive the transmitted
signal separately. The respective more powerful antenna sig-
nal is then internally switched to the input of the receiving
part.
When using two microphone systems with different
frequencies, signals from two microphones can be
transmitted on different channels. It is possible to com-
bine e. g. the following wireless microphones from the
"img Stage Line" range with the TXS-8.. receivers:
Type
Hand-held microphone
with integrated trans-
mitter
Pocket transmitter for
headband microphone
HSE-100
Pocket transmitter with
tie-clip microphone
Pocket transmitter with
headband microphone
Type
Diversity*
Diversity*
suitable for suitable for
TXS-840 TXS-842
TXS-821HT TXS-822HT
TXS-820HSE TXS-822HSE
TXS-820LT TXS-822LT
TXS-820SX TXS-822SX