Quick TCD 1062 Mode D'emploi Et D'installation page 16

OPERATION
GB
TCD 1062 ENABLING (THRUSTER COMMAND)
To enable the TCD 1062, press the enabling button and keep it pressed for at least 1 second (without the mushroom
push-button switch pressed).
After this time, the enabling LEDs will start flashing faster.
Releasing the enabling button, the enabling Leds and the Power ON Leds will remain on and the TCD 1062 will be ena-
bled.
THRUSTER ACTIVATION
Bow thruster activation
When controlling the thruster, the relative direction LED will remain on.
Stern thruster activation
As space is limited in the bow, some boats are only equipped with a stern thruster.
In this case, this thruster will be used the same way as the bow thruster (see paragraph Bow thruster activation).
WARNING: once the direction joystick has been released, the boat will continue to move according to the inertia
of the movement.
16
To move the bow to the right, move the joystick to
the right at the end of its stroke.
To move the bow to the left, move the joystick to
the left at the end of its stroke.
TCD 1062 - REV001A