Quick TCD 1062 Mode D'emploi Et D'installation page 12

CHARACTERISTICS AND INSTALLATION
GB
TCD 1062 - Remote control with integrated line switch control
TCD 1062 can only work in a system with a TMS line switch.
TCD 1062 was designed to control manoeuvre thrusters manufactured by Quick
Other important advantages of the TCD 1062 are:
• Simple and intuitive user interface.
• Universal supply (from 8 to 31 Vdc).
• Can work in a wide range of ambient temperatures.
• Possibility of connecting several TCD remote controls in parallel.
• Easy to install by means of connectors (optional extensions).
• Automatic priority system.
• Protection against reverse polarity, output short circuit, prolonged activity of thrusters and interruption of thrusters
controls wiring.
• Integrated thruster (TSC) line switch control.
INSTALLATION
BEFORE USING THE TCD 1062, READ THIS INSTRUCTION MANUAL CAREFULLY.
IN CASE OF DOUBTS, CONTACT QUICK
F
In case of discordance or errors in translation between the translated version and the original text in the Italian
language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
The TCD 1062 is designed and constructed for the purposes described in this instruction manual. Quick
held responsible for any direct or indirect property damage or personal injury caused by inappropriate or unintended
use of the TCD 1062, incorrect installation or any errors that may be present in this manual.
THE WARRANTY SHALL BE VOID IF THE TCD 1062 IS TAMPERED WITH OR ALTERED BY NON AUTHORISED
PERSONNEL.
THE PACKAGE CONTAINS: TCD 1062 - frame - drilling template - conditions of warranty - manual for use and installa-
tion.
INSTALLATION OF THE TCD 1062
The typical installation procedure is described herein, it is not possible to describe a procedure applicable for all situa-
tions that may be encountered.
Adapt this procedure to satisfy your own personal requirements.
Locate the most suitable position to house the TCD 1062 following the recommendations given below:
• The TCD 1062 must be positioned so that it can easily be manoeuvred by the operator.
• Select a smooth and flat area.
• Access from the rear must be available for installation and maintenance purposes.
• There must be enough space behind the chosen position in order to accommodate the rear of the TCD 1062 and the
wires.
• The rear part of the TCD 1062 must be protected from water and damp.
• Pay careful attention when drilling the panels or parts of the boat.
These holes should not weaken or break/crack the boat's structure.
12
Manual for use and installation
®
CUSTOMER SERVICE OR YOUR LOCAL DEALER.
®
.
®
.
TCD 1062 - REV001A
®
shall not be