Publicité
Les langues disponibles
Les langues disponibles
7
RIGHT HAND
SIDE
LEGEND
ITEM 1 = BC0002 CRASH PROTECTOR CAPS (x2).
ITEM 2 = B0061 with CS341 (10mm) (L-H-S CRASH PROTECTOR) (x1).
ITEM 3 = S0475 SPACER 39mm LONG (L-H-S SPACER) (x1).
ITEM 4 = M10x1.5x130mm LONG HEX HEAD BOLT (L-H-S CRASH PROTECTOR BOLT) (x1).
ITEM 5 = LW0001 (M12 SHAKE PROOF WASHERS) (x2).
ITEM 6 = M10 PLAIN WASHERS (x2).
ITEM 7 = S0142 SPACER 24mm LONG (R-H-S SPACER) (x1).
ITEM 8 = B0063 with CS066 (10mm) (R-H-S CRASH PROTECTOR) (x1).
ITEM 9 = M10x1.5x100mm LONG HEX HEAD BOLT (R-H-S CRASH PROTECTOR BOLT) (x1).
You will need the following tools to complete this job.
Socket set to include T25 and T50 male socket and 17mm A/F socket and wrench.
FITTING INSTRUCTIONS
Near side (left side as you sit on bike)
Remove the engine mounting bolt arrowed in picture 'A' (using T50 male socket).
Slide one of the 10mm washers onto the longer M10 hexagon headed bolt so washer sits against
head of bolt.
Slide serrated locking washer over the bolt so it sits against washer just fitted.
Next slide bolt and washer through the longer bobbin so head of bolt goes into counter-bore in
bobbin.
Next slide the longest spacer (39mm long) over bolt so larger diameter sits against bobbin (the
amount of bolt protruding from spacer should be the same as the original engine mounting bolt
=50mm).
Offer this assembly up to frame mount and tighten bolt until you feel some compression from
inside the protector using 17mm socket and wrench. PLEASE NOTE BOBBIN MUST BE
POSITIONED AS IN PICTURE 'C' ABOVE WITH BIGGER END TOWARD FRONT OF
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
5
28MM hole-saw.
Torque wrench to be used at 40NM.
R&G Racing
www.rg-racing.com
8
1
9
6
Email:
info@rg-racing.com
Publicité
