Publicité
Liens rapides
Publicité
Manuels Connexes pour Wallenstein LXG210S
Sommaire des Matières pour Wallenstein LXG210S
- Page 1 Set-up Instructions LXG210S LXG210SB Part Number: Z97109-SI Rev Nov-2019...
- Page 2 (23 kg) or more to avoid back injury. All lifting devices (straps, slings, chains, ratchet blocks) must comply with applicable local regulations and certifications. Wallenstein Equipment Inc. cannot accept responsibility for the use of sub-standard equipment and work practices. Use lifting equipment with a capacity greater than the weight of the component.
- Page 3 LXG210S LXG210SB...
- Page 8 Pre-operation Checklist Check the machine has been lubricated following the schedule outlined in the Maintenance section. Check that the machine is properly attached to the skid steer. Check that the grapple pivot rotates freely 180º and the lock functions properly. Check for hydraulic leaks.
- Page 9 Bolt Torque Specifications Imperial Bolt Torque Specifications Checking Bolt Torque Torque Value The tables shown give correct torque values for Bolt SAE Gr. 2 SAE Gr. 5 SAE Gr. 8 various bolts and capscrews. Tighten all bolts to the Diameter torque values specified in the table, unless indicated lbf•ft N•m...
- Page 10 Hydraulic Fitting Torque Hydraulic Fitting Torque 1. Check flare and flare seat for defects that might cause leakage. Hex Size Tube Size Flats From Finger Across Torque value 2. Align tube with fitting before tightening. Tight Flats 3. Hand-tighten swivel nut until snug. lbf•ft Inches Inches...