Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LOCATION AND INSTALLATION
COUNTERTOP
1) Chamfer all exposed edges of decorative laminate to prevent damage from chipping.
EN
2) Radius corners of cutout and file to ensure smooth edges and prevent corner cracking.
3) Recommend 1/4"or 3/8" diameter drill in each corner.
4) For solid surface countertops, refer to countertop material manufacturer instructions.
SOLID SURFACE COUNTERTOPS
NOTICE
Important: For solid surface material
installations such as Surel™ and Corian®,
consult with solid surface manufacturer.
Apply heat reflective tape such as Scotch®
Aluminum Foil Tape #425 or #427 around the
cutout so that it folds over on the top and
sides.
DO NOT WRAP THE TAPE UNDERNEATH
THE COOKTOP.
Be sure the tape extends beyond the
outermost flange of the cooktop. All corners
should be covered with tape.
NEW INSTALLATIONS
For new installations, the
minimum cut-out size is
preferable.
6
©2019 Hestan Commercial Corporation
Figure 8.
Cooktop
A
Model
MIN 28-1/2" [72.4 cm]
KGC30
MAX 29"
[73.7 cm]
MIN 34-1/2" [87.6 cm]
KGC36
MAX 35"
[88.9 cm]
(continued)
Figure 7.
Solid Surface Protective Tape
Cutout Requirements (1/2)
B
MIN 19-1/2" [49.5 cm]
MAX 19-5/8" [49.8 cm]
MIN 19-1/2" [49.5 cm]
MAX 19-5/8" [49.8 cm]
C
D
MIN 2"
MIN 3-1/2"
[5.0 cm]
[9.0 cm]
MIN 2"
MIN 3-1/2"
[5.0 cm]
[9.0 cm]
Publicité
Table des Matières
