Electrical Connection - hestan KGC30 NG/-LP Manuel D'installation

ELECTRICAL CONNECTION

GENERAL INFORMATION
This appliance must be supplied with the proper voltage and frequency and connected to an
individual, properly grounded branch circuit, protected by a circuit breaker or fuse having
EN
amperage as noted on page 2 of this manual. We recommend you have the electrical wiring and
hookup of your cooktop connected by a qualified electrician.
After installation, have the electrician show you where your cooktop's circuit breaker is located.
Check with your local utilities for electrical codes which apply in your area. Failure to wire your
cooktop according to governing codes could result in a hazardous condition.
If there are no codes, your cooktop must be wired and fused to meet the requirements of the
National Electrical Code, ANSI/NFPA No. 70 - Latest edition. You can get a copy by writing:
National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02169-7471
In Canada your cooktop must be wired and fused to meet the requirements of the Canadian
Electrical Code.
Be sure the installation of this product in a mobile home conforms with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured Home Installations, Sites and Communities and
ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard by Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010
ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Before turning
power ON, be sure all controls are in the OFF position. Failure to do so can
result in death or electrical shock.
ELECTRICAL GROUNDING REQUIREMENT
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
Plug into a grounded 3 prong outlet. Do not remove ground
prong. Do not use an adapter. Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
ELECTRICAL CONNECTION
The receptacle must be on its own dedicated circuit - 120 VAC,
Single Phase, 60 Hz, with a current rating of 15 Amps. If this is
not available, a licensed electrician must install the appropriately
dedicated and grounded receptacle.. The installation must be
done in accordance with local codes, or in the absence of local codes, it must be installed in
accordance with the National Electrical Code, ANSI/NFPA 70.
16
©2019 Hestan Commercial Corporation
GROUNDING PRONG
Figure 18. Three Prong Cord and
Receptacle