hestan KGC30 NG/-LP Manuel D'installation page 21

CONVERSION
REPLACING ORIFICES ON CENTER (DUAL-RING) BURNER (KGC30, 36)
1) Remove the grates and burner caps (A).
2) Remove gas spreader (B).
3) Remove the orifice cover screw (C). Remove the orifice cover.
4) The center orifice (D) can be removed by using a 9/32" nut driver (Counter-clockwise).
5) The other two orifices (E) can be removed by using a 9/32" box wrench (Counter-
clockwise).
6) Install the orifices supplied with this appliance in the appropriate burner. Each orifice has
a number stamped on the side, which identifies the orifice diameter. (See Figure 23 for the
orifices to use in each burner position).
7) Turn clockwise to tighten. Tighten to a torque of 15 to 20 inch-lbs. [1.7-2.3 N-m].
8) Replace all parts following the reverse order.
9) Save the orifices removed from the appliance for future use.
A
B
C
Figure 21. Center (Dual Ring) Burner
(continued)
D
©2019 Hestan Commercial Corporation
EN
E
19