Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION
The power cord of this appliance is equipped with a 3- prong (grounding) plug which must be
used with a properly grounded 3-hole outlet with a standard 120 Volt, 60 cycle AC household
current. If you do not have a 3-hole grounded outlet, have a qualified electrician change your
old one.
ELECTRICAL REQUIREMENTS
Do not under any circumstances cut or remove grounding prong from the cooktop cord.
1
2
1
2
3
3
4
5
4
5
WIRING DIAGRAM / DIAGRAMME DES CABLES
Figure 19. Wiring Diagram
VENTILATION REQUIREMENTS
It is strongly recommended that this appliance be installed with a Hestan vent hood. Due
to the high heat output of this cooktop, it is very important that the hood and ductwork
installation meets local building codes and is installed by a qualified technician.
Do not use a down-draft style ventilation system.
Do not mount a microwave oven/ventilator combination above the cooktop. This type of unit
does not have sufficient airflow to remove the high heat output of this cooktop.
For non-Hestan-approved vent hoods, the vent hood and/or blower unit must be rated for 1
CFM [1.7 m³/hr] for every 100 BTU [.03 kW].
For island applications, it is recommended to use a vent hood that is 6" [15.2 cm] wider than
the appliance, to allow for 3" [7.6 cm] of overlap on the left and right of the appliance.
Keep duct runs as short and straight as possible. Elbows and transition fittings reduce airflow
efficiency. Hestan recommends keeping the duct run under 50 ft. [15.2 m].
CONSULT WITH YOUR HESTAN DEALER ON SELECTING THE
APPROPRIATE VENT HOOD FOR YOUR HESTAN APPLIANCE.
(continued)
N
L
TERMINAL
BLOCK
N
L
1
IN
OUT
2
IN
OUT
3
IN
OUT
4
IN
OUT
5
IN
OUT
N
L
5 SINGLE
OUT
RE-IGNITER
(ALTERNATIVE)
SYSTEMS
1
2
3
J13 J12 J14
4
5
J3
J10
J8
J6
J4
J2
LED KNOB SYSTEM
©2019 Hestan Commercial Corporation
EN
17
Publicité
Table des Matières
