hestan KGC30 NG/-LP Manuel D'installation page 15

Masquer les pouces Voir aussi pour KGC30 NG/-LP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GAS CONNECTION
GAS CONNECTION
After connecting, the installation must be
checked for leaks. That procedure is on the
following page.
Connect to gas supply using a minimum 1/2"
inside diameter flexible (semi–rigid) stainless
steel gas hose to prevent gas starvation. This
hose should be no more than 36" [91.4 cm] in
length, or as permitted by applicable codes.
The included regulator must be installed
between the shutoff valve and the appliance, and
must be mounted so that its directional arrow
(flow direction) points toward the gas manifold.
NEVER REUSE OLD HOSES WHEN
INSTALLING THIS COOKTOP.
ANSI Z21.24/CSA 6.10 and ANSI Z21.75/CSA
6.27 codes require that a new gas appliance hose
must be used for a new appliance, when moving
an appliance to a new location, or as a result of
damage.
Use the appropriate thread sealant on all NPT
connections. Do not apply sealant to flare
fittings.
NEVER TIGHTEN TO MORE THAN 35 ft-lbs
[47.4 N-m] OF TORQUE.
Check alignment of valves after connecting
the cooktop to the gas supply to be sure
the manifold pipe has not been moved. A
misalignment could cause the valve knob stem to
rub on the control panel, resulting in a gas leak at
the valve.
CAUTION
Do not attempt to attach the flexible hose directly to an external pipe thread. Connection
requires proper adapters to join the flex hose and the pipe fittings.
FOR MASSACHUSETTS INSTALLATIONS:
1. Shut-off valve must be a "T" handle gas cock.
2. Flexible gas hose must not be longer than 36 inch [91.4 cm].
3. Not approved for installation in a bedroom or a bathroom unless unit is direct vent.
(continued)
APPLIANCE PRESSURE
REGULATOR, SUPPLIED
(OBSERVE GAS FLOW
DIRECTION)
[91.4 cm] MAX
1/2" NPT PIPE
(STATIONARY
SUPPLY PIPE)
MOUNTED BELOW
Figure 15. Typical Methods Of Connecting Gas
MANIFOLD
ENTRANCE
GASKET
GASKET
*****
--- to
ADAPTOR
1/2" NPT
ELBOW
FLARE
ADAPTOR
FLEXIBLE
APPLIANCE PRESSURE
GAS HOSE
REGULATOR, SUPPLIED
36" MAX
(OBSERVE GAS FLOW
DIRECTION)
FLARE
ADAPTOR
GAS
SHUT-OFF
VALVE
NO APPLIANCE
THIS COOKTOP
©2019 Hestan Commercial Corporation
FLARE
ADAPTOR
FLEXIBLE
GAS HOSE
36" MAX
[91.4 cm] MAX
FLARE
ADAPTOR
1/2" NPT
PIPE NIPPLE
GAS
SHUT-OFF
VALVE
1/2" NPT PIPE
(STATIONARY
SUPPLY PIPE)
WALL OVEN MOUNTED
IN CABINETRY BELOW
THIS COOKTOP
13
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kgc36 ng/-lpKgc serieKgc30 ngKgc30 ng-lpKgc36 ng

Table des Matières