Handlebar Assembly - YT Industries CAPRA RTFM Mode D'emploi

UNBOX YOUR BIKE
Cut the packaging straps using wire cutters Lift the wheels out of the box. Put the wheels
1.1 1.2
or a box cutter. Just make sure not to da- in a safe place on the side of the box.
mage the YT BikeBox. Now you can pull out
the flaps and open it.
Place the frame on the front /rear axle stand.
1.4
Make sure the bike is standing safely!
TIP: keep the box and the packing materials
for potential future shipments of your bike.
0 6 y t
Now you can lift your bike upwards, out of
1.3 2.2.1
the box.
TOOLBOX
01 MANUALS
0 1
02 TOOLS
0 2
03 TECHNICAL
0 3
READ
2.2.4
ME
FIRST

HANDLEBAR ASSEMBLY

E 13 PL US /BA SE
Remove the cable ties using a wire cutter. Install the handlebar. Mount the handlebar to
2.2.2
Remove the stem screws and put them aside the stem.
(T25 Torx).
Make sure that the clamp gaps under the low-
er stem bolts are even, and that the handlebar
is correctly centered and aligned in the stem
– there are markings to assist you with this.
Torque all bolts precisely to the spec indicated
by the stem and/or handlebar manufacturer.
Start with the uppermost bolts, torqueing
2.2.3
down the top part of the stem clamps ac-
cording to the manufacturer's specifications.
Take care not to leave a gap here (zero gap).
Only then should you secure the handlebar
with the lower bolts as well.
P l ea se f ol l ow t h e
t o rq u e sp e c i fi c at i on s of
t h e m a n u fac t u rer s:
E13 Plus:
Steerer tube screws // 7 Nm
Handlebar clamp screws // 7 Nm
E13 Base:
7 Nm
Steerer tube screws //
7 Nm
Handlebar clamp screws //
y t 0 7