Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASP17:
The ASP17 mounting plate is suitable for the sturdy fixing of lock casings. It is used, in
particular, when the options for anchoring the reinforced door bar lock casings directly
and securely to the subsurface are inadequate (Fig. 36-38).
Scope of delivery ASP17
4x
6x
8x
6x
2x
G
4x
2x
Abb. 36
Abb. 37
3
2
2
4
6
5
3*
2
5
6
4
2
2
3
* optional
Abb. 38
46
1. Establish the position of the lock casings and thus of
the mounting plate in accordance with the relevant
PR fitting instructions. Note: pay attention to
position – angled position of the plugs in relation to
the masonry.
2. For basic fitting, attach the mounting plate with
screws (E) and, if necessary, plugs (G) in the holes (2)
as an option.
3. Also fix the mounting plate with the long-shaft
fixing (C) through the angled holes (3).
4. If the hold is not adequate, the mounting plate can
also be anchored with a combination of M8
threaded rods through the two holes (4) and
injection mortar (not supplied).
5. As an option, additional longer long-shaft fixings
(C, not supplied) can be used for anchoring through
the central hole (3).
6. Fit cover (A).
7. Provide the lock casings of the reinforced door bar
with appropriate supports and screw in place in the
required position (fix with 2 selftapping screws (D).
If the rebate height is too small, it may be
necessary to use a lock body support.
Underlay for the lock body
The lock body underlay allows for a more favourable assembly position of the wall cover plates to be
achieved, as these can be mounted in a more stable area of the doorframe / wall as a result
(Fig. 39-41).
Note: to determine the cylinder length required (table 1, page 37), the underlay thickness of
18 mm must be added to the existing thickness of the door leaf.
Fig. 39
Fig. 40
NRS PR-Alarm:
Equipment kit for an alarm function of the reinforced door bar (Fig. 42).
Simple retrofit by replacing the lock casing caps.
Sounds at 110 decibels → see separate instructions enclosed with the product.
Fig. 42
IX. Disposal
At the end of its service life, dispose of the product in accordance with the applicable legal require-
ments. Dispose of the packaging according to type. Separate the cardboard, foil and plastic elements
for recycling. Please contact the local authority responsible for disposal if you have any queries.
Warranty
ABUS products are designed, manufactured and tested in accordance with applicable regulations
with great care. The warranty exclusively covers faults that are caused by material or manufacturing
defects. If a material or manufacturing defect can be proven, the product will be repaired or replaced
at the discretion of the warrantor. In such cases, the warranty ends with the termination of the origi-
nal warranty period. Any further claims are expressly excluded.
ABUS assumes no liability for defects or damage that has been caused by external influences (e.g.
transport, external forces), improper use, normal wear and tear or non-compliance with this oper-
ating and installation instructions document. If a warranty claim is asserted, the product must be
returned with the original receipt with date of purchase and a brief written description of the fault.
Subject to technical alterations. No liability for mistakes and printing errors.
© ABUS 2022
ABUS August Bremicker Söhne KG | D 58292 Wetter | Germany
Tel.: +49 (0) 23 35 63 40 |
Fig. 41
GB
|
47
Publicité
Table des Matières
