Description Of The Appliance; Assembly; Start Up - Kärcher K 7 Full Control Plus Mode D'emploi

Description of the Appliance

The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
See fold-out page 4 for illustrations
1 Coupling element for water connection
2 Water connection with integrated sieve
3 High pressure hose
4 Hose guide
5 Storage for spray lances
6 Storage / parking position for trigger gun
7 Connection for Plug 'n' Clean detergent
8 Carrying handle
9 Transport handle, detachable
10 Hose holder
11 High pressure connection
12 Appliance switch „0/OFF" / „I/ON"
13 Mains cable with mains plug
14 Accessory compartment
15 Hooks for fastening the net
16 Net for accessory compartment
17 Bearing wheel
18 Base with carrying handle
19 Full Control trigger gun
20 Battery compartment
21 Battery compartment lock
22 LCD display
23 Battery status (empty, almost empty, medium, full)
24 Signal strength status (four levels)
25 Spray type recommendation (flat stream/detergent/
dirt blaster)
26 Area of application (1 - SOFT / 2 - MEDIUM / 3 -
HARD with two pressure levels each)
27 Detergent level (1 / 2 / 3)
28 Pressure regulation + / -
29 Lock trigger gun
30 Button for detaching the high-pressure hose from
the trigger gun
31 3-in-1 multi jet spray lance (with three spray types)
32 Detergent nozzle (three dosing levels) - For dosing
detergents
33 Flat jet nozzle (three areas of application with two
pressure levels each) - for the most common clean-
ing tasks.
34 Dirt blaster (one area of application with two pres-
sure levels) - for stubborn contamination.
* Optional accessories
35 Plug 'n' Clean detergent bottle with locking lid
** Additionally required
36 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
12
See fold-out page 3 for illustrations
Mount loose parts delivered with appliance prior to start-
up.
Attach the net to the accessory compartment
Illustration
 Hook the net into the hooks shown in the illustra-
tion.
Winding off the high pressure hose
 Completely wind off the high-pressure hose and
disentangle any loops and knots.
Putting the high pressure hose through the
Illustration
 Put the disentangled high-pressure hose through
the hose guide from the back.
 Pull the high-pressure hose completely through the
hose guide to the front.
Coupling of the high-pressure gun
Before initial startup, the high-pressure
gun must be coupled to the high-pressure
cleaner.
 Insert the mains plug into the socket.
 Within one minute, simultaneously
press the + and - buttons on the high-
pressure gun.
 Hold down the buttons until the entire
signal strength symbol flashes.
Once coupling is complete, all six pressure levels
will be displayed.
Note: You can find a detailed description of the coupling
here: https://www.kaercher.com/FCR
ATTENTION
The highest allowed net impedance at the electrical
connection point (refer to technical data) is not to be ex-
ceeded. In case of confusion regarding the power im-
pedance present on your connection, please contact
your utilities provider.
 Park the appliance on an even surface.
Illustration
 Push the high pressure hose into the trigger gun
until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
 Check the secure connection by pulling on the high
pressure hose.
 Insert the mains plug into the socket.
– 6
EN

Assembly

hose guide.

Start up