auna TT-Play Mode D'emploi page 21

Replacing the stylus
Push the arm lock Take off the cap of
to release the the cartridge to
tone-arm. expose the needle.
Installing a new stylus cartridge
To fit a new cartridge, perform steps 5-8 below.
Note: Please take extreme care whilst performing this operation to avoid
damaging the tone arm and audio wires.
Carefully insert Make sure the
the audio-lines. audio-lines are
not touching
each other.
Transport
When transporting your record player do not forget to:
• Place the protective cap on the stylus.
• Put the rest clip into the pick-up arm.
Separate the Gently pull the
cartridge from the audio-lines from
cartridge the cartridge,
holder. taking care to pull
from the terminal
connector and not
the wire itself.
Carefully slide Gently clip the
the cartridge cartridge into
into the the cartridge
cartridge holder. holder.
EN
21