Stadler Form Max Mode D'emploi page 7

receptacles should be replaced prior to further use of the heater. Plugging
heater into a worn outlet/receptacle/ may result in overheating of the
power cord or fire.
• This heater is not intended for use with an extension cord. Plug the cord
directly into an appropriate wall receptable.
• Be sure that the plug is fully inserted into an appropriate receptacle.
Please remember that receptacles also deteriorate due to aging and con-
tinuous use: check periodically if signs overheating or deformations are
evidenced by the plug. Do not use the receptacle and CALL your electri-
cian.
• Check that neither the appliance nor the power cable have been damaged
in any way during transportation.
• CAUTION: to prevent electric shock match wide blade of plug to wide
slot, fully insert.
• Always use the heater in an upright position.
• Do not use the appliance close to walls, furniture, curtains etc.
• Do not cover the appliance when in operation as this could cause over-
heating and a possible fire.
• Do not use the appliance in rooms less than 43 square feet (4m
• For indoor use only.
• Do not store the appliance outdoors.
• The heater is fitted with a safety thermal cut-off which will switch off
the appliance.
• The heater must not be located directly below a power outlet.
• Unplug the appliance before filling and cleaning.
Setting up / operation
1. Having set up the Max heater in the desired position, insert the mains
cable (7) into the mains socket (6) on the appliance and connect the cable
(7) to the household supply socket.
2. Switch on Max to the desired level by means of the rotary control (1).
3. Rotary control (1):
Position 0
Position
Position I
Position II
4. Room thermostat (2): The room-thermostat control (2) allows for a vari-
able temperature adjustment.
Setting: for maximum temperature, turn the control clockwise,
for minimum temperature, turn the control anti-clockwise.
Recommendation: Turn the thermostat control (2) clockwise as far as
the stop. If the desired room temperature has been reached, turn the
thermostat control (2) anticlockwise until the appliance switches off.
If the room temperature drops, then Max switches on again automati-
cally. Please note that after the thermostat switches off automatically, it
takes a few minutes for the heater to switch on again!
5. Frost-protection circuit
prevent the room temperature from falling below approx. 41 °F / +5 °C,
set the rotary control (1) to position I or II (depending on the size of room,
Position II for larger rooms) and the room-temperature control (2) to
= Off
= Ventilation, turn the room-thermo-
stat rotary control (2) clockwise as
far as the stop
= Heating, 750 W
= Heating, 1500 W
*
: Set the room-thermostat control (2) to
).
2
*
. To
*
.