GE JCBP49 Manuel Du Propriétaire Et Instructions D'installation page 29

Table des Matières

Publicité

Problem
Oven temperature too
hot or too cold
Oven will not work
Storage drawer
is crooked
Storage drawer
won't close
Oven will not self-clean
"Crackling" or
"popping" sound
Excessive smoking
during a clean cycle
Oven door will not open
after a clean cycle
Oven not clean after
a clean cycle
Possible Causes
Oven thermostat
needs adjustment.
Plug on range is not
completely inserted in
the electrical outlet.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls improperly set.
Oven too hot.
Rear drawer support is
on top of the guide rail.
Power cord may be
obstructing drawer
in the lower back
of the range.
Rear drawer support is
on top of the guide rail.
The oven temperature is
too high to set a self-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil.
Oven too hot.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled.
What To Do
• See the Adjust the oven thermostat—Do it yourself!
section.
• Make sure electrical plug is plugged into a live,
properly grounded outlet.
• Replace the fuse or reset the circuit breaker.
• See the Using the oven section.
• Allow the oven to cool to below locking temperature.
• Reposition the drawer. See the Storage Drawer
Removal instructions in the Care and cleaning of your
range section.
• Reposition the drawer and power cord. See the
Storage Drawer Removal instructions in the Care and
cleaning of your range section.
• Reposition the drawer. See the Storage Drawer
Removal instructions in the Care and cleaning of your
range section.
• Allow the oven to cool to room temperature and
reset the controls.
• This is normal.
• Press the OFF pad. Open the windows to rid the
room of smoke. Wait until the light on the
CLEAN pad goes off. Wipe up the excess soil and
reset the clean cycle.
• Allow the oven to cool below locking temperature.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
www.GEAppliances.ca
29

Publicité

Table des Matières
loading

Table des Matières