GE JCBP49 Manuel Du Propriétaire Et Instructions D'installation page 20

Table des Matières

Publicité

Care and cleaning of the range.
The gasket is designed with a gap at the
bottom to allow for proper air circulation.
Do not rub or clean the door gasket—
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it
has become displaced on the door,
you should have it replaced.
Hinge lock
Slot
(unlocked
position)
Hinge arm
Removal position
20
Cleaning the Oven Door
To clean the inside of the door:
I
Because the area inside the gasket is cleaned
during the self-clean cycle, you do not need to
clean this by hand.
I
The area outside the gasket and the door liner
can be cleaned with a soap-filled steel wool or
plastic pad, hot water and detergent. Rinse
well with a vinegar and water solution.
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Push the hinge locks down toward
the door frame, to the unlocked
position. This may require a
flat-blade screwdriver.
Close door to the door removal
position.
Firmly grasp both sides of the door
at the top.
Lift door up until the hinge arm is
clear of the slot.
To clean the outside of the door:
I
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to clean
the glass on the outside of the door. Do not let
water drip into the vent openings.
I
If any stain on the door vent trim is persistent,
use a soft abrasive cleaner and a sponge-
scrubber for best results.
I
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing acids
may cause discoloration and should be wiped
up immediately. When surface is cool, clean
and rinse.
I
Do not use oven cleaners, cleaning powders or
harsh abrasives on the outside of the door.
To replace the door:
Firmly grasp
Bottom
both sides of
edge
of slot
the door at
the top, with
the door at the
same angle as the
removal position.
Seat the indentation
on the bottom of the hinge arm into
the bottom edge of the hinge slot.
Fully open the door.
Push the hinge locks up against the
front frame of the oven cavity to the
locked position.
Locked
Position
Seated
Hinge Arm
Close the oven door.
Hinge arm
Indentation

Publicité

Table des Matières
loading

Table des Matières