Replacing The Light Bulb; Cleaning The Feed Dog - Elna 664 Mode D'emploi

4
1
1, 2, 3, 4
3
5, 6
All manuals and user guides at all-guides.com

Replacing the Light Bulb

1. Turn off the power switch and unplug the machine.
1
2. Remove the face plate setscrews, and remove the
2
To remove:
Push and twist to the left.
To attach:
Push and twist to the right.
Reattach the face plate, and tighten the face plate
setscrews.
3
5
Note:
* The machine is designed to use a 15 WATT
* The light bulb will be HOT. Protect your fingers

Cleaning the Feed Dog

1. Turn off the power switch and unplug the
2. Open the looper cover and side cover.
2
3. Remove the needles and presser foot.
4. Remove the needle plate set screw, and remove
5. Brush out the lint around the feed dogs to the
6. Reattach the needle plate, presser foot and
76
face plate.
1 Face plate
2
Setscrews
3 Light bulb
4
To remove
5
To attach
maximum light bulb.
when you handle it.
machine.
the needle plate.
1 Needle plate
2
Needle plate set screw
front by using the lint brush or use a vacuum
cleaner.
needles.
Close the looper cover and side cover.
3 Feed dogs