Displaying Version Information - Avocent AutoView 3100 Mode D'emploi

34
AutoView 3100/3200 Switch Installer/User Guide
4. Click OK to disconnect the user and return to the User Status dialog box.
-or-
Click X or press
NOTE: If the User Status list has changed since it was last displayed, the mouse cursor will turn into an
hourglass as the list is automatically updated. No mouse or keyboard input will be accepted until the list update
is complete.
Resetting your PS/2 keyboard and mouse
NOTE: This function is for Microsoft Windows-based computers only. Resetting the PS/2 on a target device
running any other operating system may require that you reboot that target device.
If your PS/2 keyboard or mouse locks up, you may be able to re-establish operation of these peripherals
by issuing a Reset command. The Reset command sends a hot-plug sequence to the target device which
causes the mouse and keyboard settings to be sent to the AutoView 3100/3200 switch. With
communication re-established between the target device and the AutoView 3100/3200 switch,
functionality is restored to the user.
To reset the PS/2 mouse and keyboard values:
1. If the OSCAR interface is not open, press
2. Click Commands - Reset PS/2. A message box displays requesting that you confirm the reset.
3. In the message box, click OK.
a. A message appears indicating that the mouse and keyboard have been reset.
b. Click X to close the message box.
-or-
Click X or press
and keyboard.

Displaying version information

The OSCAR interface enables you to display the version number of the switch firmware and any
auxiliary devices connected to the switch. This information facilitates system troubleshooting and
support. For optimum performance, keep your firmware current.
To display version information:
1. If the OSCAR interface is not open, press
2. Click Commands - Display Versions to open the Version dialog box shown in Figure 3.18 on
page 35. The top half of the box lists the subsystem versions.
All manuals and user guides at all-guides.com
to exit the dialog box without disconnecting a user.
Escape
to exit without sending a Reset command to the PS/2 mouse
Escape
to open the Main dialog box.
Print Screen
to open the Main dialog box.
Print Screen