Avocent AutoView 3100 Mode D'emploi page 83

To configure an AVRIQ-SRL module:
1. Press
Ctrl-F8
2. Select a parameter to change. You can navigate the Configuration Screen using the
and
Down Arrow
3. Modify the selected value using the
4. Repeat steps 2 and 3 to modify additional values.
5. Press
Enter
-or-
Press
Escape
Creating an AVRIQ-SRL module macro
Pressing the
Page Down
displayed will provide access to the Macro Configuration screen. The AVRIQ-SRL module can be
configured with up to 10 macros. Each macro can be up to 128 characters in length.
To create a macro:
1. Select the AVRIQ-SRL module you wish to configure and press
nal Applications menu's Configuration screen.
2. When the Terminal Applications menu appears, press
screen. The Macro Configuration screen shows the 10 available macros and the associated key
sequences, if any, for each.
3. Using the
Up Arrow
the listed keystroke sequence. Type the new macro keystroke sequence over the default. Any
combination of
keystroke sequence that will activate the new macro, press the
4. On the line below the macro keystroke sequence you just entered, type the keystroke sequence
that you wish the macro to perform.
5. Repeat steps 3 and 4 to configure additional macros.
6. When finished, press
Using History mode
History mode allows you to examine the contents of the history buffer, which contains the events
that have occurred.
The AVRIQ-SRL module maintains a buffer containing 240 lines minimum, or 10 screens, of
output. When the history buffer is full, it will add new lines at the bottom of the buffer and delete
the oldest lines at the top of the buffer.
NOTE: The Config Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the
following procedure are the default values. These key combinations can be changed using the Terminal
Applications menu.
All manuals and user guides at all-guides.com
. The Configuration Screen will appear.
keys.
to save your changes and exit the Configuration Screen.
to exit the Configuration Screen without saving the changes.
key when the Terminal Applications menu's configuration screen is
and
Down Arrow
or and a single key may be used. When you have finished entering the
Ctrl Alt
to return to the previous screen.
Enter
and
Left Arrow Right Arrow
Page Down
keys, scroll to an available macro number and highlight
Appendices
Up Arrow
keys.
to activate the Termi-
Ctrl-F8
to view the Macro Configuration
key.
Down Arrow
71