Table B.1: Avriq-Srl Module Pinouts - Avocent AutoView 3100 Mode D'emploi

72
AutoView 3100/3200 Switch Installer/User Guide
To use History mode:
1. Press
Ctrl-F9
2. Press one of the following key combinations to perform the indicated action:
•
Home
• : Move to the bottom of the buffer.
End
•
Page Up
•
Page Down
•
Up Arrow
•
Down Arrow
•
Ctrl-F8
•
Ctrl-F9
mode enabled.
•
Ctrl-F10
mode enabled.
•
Ctrl-F11
Press
Enter
screen will reappear.
3. When finished, press
AVRIQ-SRL module pinouts
Table B.1 lists the pinouts for the AVRIQ-SRL module.

Table B.1: AVRIQ-SRL Module Pinouts

DB9-F
Host Signal Name Description
Pin
1 DCD - Data Carrier Detect
2 RXD - Receive Data
3 TXD - Transmit Data
4 DTR - Data Terminal Ready
5 GND - Signal Ground
6 AutoView - Data Set Ready
7 RTS - Request to Send
8 CTS - Clear to Send
9 N/C - Not Connected
All manuals and user guides at all-guides.com
. The mode will display as History.
: Move to the top of the buffer.
: Move up one buffer page.
: Move down one buffer page.
: Move up one buffer line.
: Move down one buffer line.
: Enters Configuration mode. The Configuration screen will appear.
: While in Configuration mode, return to the previous screen with History
: While in Configuration mode, return to the previous screen with On-Line
: Clears the history buffer. If you choose this option, a warning screen will appear.
to delete the history buffer, or
to exit History mode and return to On-Line mode.
Ctrl-F10
to cancel the action. The previous
Escape
Signal Flow SRL Signal Name Description
Out of SRL DTR - Data Terminal Ready
Out of SRL TXD - Transmit Data
In to SRL RXD - Receive Data
In to SRL AutoView - Data Set Ready
N/A GND - Signal Ground
Out of SRL DTR - Data Terminal Ready
In to SRL CTS - Clear to Send
Out of SRL RTS - Request to Send
N/A N/C - Not Connected