auna Sarah Ann Mode D'emploi page 20

EN
20
BT CONTROL
When the tone arm set to the rest position, Bluetooth function will start
automatically. Then need to press the mode key to circle between USB/SD
and BT.
Amplifier Connection
You can listen to your new turntable using the built-in speakers, or you
may wish to connect it to your existing Hi-Fi system. Connect the "line
out" RCA ports to the "line input" on your mixer or amplifier using an RCA
cable (not supplied)
• Red plug into the right channel input
• White plug into left channel input
Playing a record
• Open the latches on the side of the unit, then lift up the lid and be sure
to secure the arm support.
• Remove the protective cover from the stylus cartridge. (See image1.)
• Place a record on the turntable. If required, place the 45 RPM adaptor
on the record spindle.
• Choose the desired playing speed (33, 45 or 78 rpm) by using the speed
selection switch.
• Turn on the rotary power switch (note that this also controls volume).
• Release the tone arm lock. (See image 2).
• Raise the arm using the cue lever and move the arm away from its
holder. This will prompt the turntable to start spinning automatically.
• Use the cue lever to slowly place the stylus down onto the record's
groove.
• If the AUTO STOP switch is set to ON, the record will stop automatically.
If it is set to OFF, the record will not stop automatically.