Emptying The Debris Compartment; Float Replacement - Kokido DELTA 100 Manuel D'utilisation

EMPTYING THE DEBRIS COMPARTMENT

WARNING! Using the robot without its filter cover in place will VOID your
warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter
cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat and sturdy surface. Pry open the side clips simultaneously
to release the top cover from the base. Pry open either side clip first before moving onto
the other one if the aforementioned method proves to be too challenging. Slide out the top
cover from the base to expose the filter cover.
2. Detach the filter cover and remove the debris from the compartment. It is
recommended to clean the filter cover net with splashing water. If brushing is deemed
necessary, use only a soft brush to clean it carefully and gently to avoid damages.
3. After cleaning, make sure that the filter cover is in place and reverse the steps above
to re-align the top cover to the base. Press on both sides of the top cover until the side
clips are secured to the base. A "click" sound will confirm the top cover is secured to the
base
TIPS: Before redeploying the robot to the pool, hold onto the wings on the body top cover
to sway the robot slightly, to ensure the top cover is secured to the base.
CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged float immediately with a new one before the next operation.

Float Replacement

Use a screwdriver (not provided) to unscrew the 4 screws at on the top cover of the swivel
head. Untie the knot on the string to remove the damaged float. Ensure the round switch
16