Emptying The Debris Compartment - Kokido Mangar RC32 Manuel D'utilisation

Blinking light - Battery power will be exhausted within 10 minutes.
NOTE:
- Refrain from making any physical contact with both water sensors.
 To retrieve the robot from the pool, if you cannot catch it by hand use the hook
provided. Attach the hook to a telescopic pole (not provided) and use it to retrieve the
float
As the robot reaches the water surface, locate the end with yellow triangle (as shown in
the image below) and grab onto the robot via the grip (Note: holding the other end of the
robot will lead to escape of debris through the drainage outlet) to lift the cleaner to drain
the water out of the robot.
5. Slide the power switch OFF. Rinse the robot with fresh water after every use. DO NOT
use any detergent.
NOTE: To ensure the most efficient cleaning, when your pool is quite dirty, it is
recommended to empty the debris compartment after the first 30min of operation,
or whenever the robot's movement has slowed down noticeably. Then return the robot
(with an emptied debris compartment) to the pool, and let it run through the remaining of
its cycle.

EMPTYING THE DEBRIS COMPARTMENT

WARNING!
Using the robot without its filter cover in place will VOID your
warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter
cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the
cover and repeat the steps on the other side to lift the entire top cover to expose the
filter cover and filter plate.
15