Operation - Kokido Mangar RC32 Manuel D'utilisation

- If you are using a saltwater pool, make sure all salt are dissolved before placing the
robot into the water.

OPERATION

WARNING!
1. Bring your robot to the side of your pool. NOTE: Do not place the robot in the pool
corner and against the pool wall as starting location. Attach the hook of the float to the
handle of the swivel head. Pry to detach the float cover and release the rope from the
float to a length equivalent to the depth of pool water plus about 0.5 meters (1.6 feet).
Put the rope inside the notch and roll the rope around the post until the cover almost
reaches the post. Put the rope inside the notch and close the cover as shown.
2. Slide the power switch to the ON position and the power indicator light will turn on.
ATTENTION: Motor activates only when the robot is submerged in water completely
Power indicator light
3. Immerse the robot into the water and operation will automatically begin as water level
covers the sensors at the top of the swivel head. Let the robot sink to the pool floor and
observe the cleaner's first forward and reversed movements across the pool bottom. If
the robot runs along the pool wall instead of perpendicular to it, reposition it to make sure
that its front/back faces the pool wall.
Power indicator light starts to blink when 10 minutes of usage remains.
Power indicator light :
No light - Power off / no power
Light - Power on
Make sure the robot is off.
(Green)
14