Operation - Kokido DELTA 100 Manuel D'utilisation

IMPORTANT NOTE: Turn off the filtration system (as instructed in your filtration
manual) at least 15 minutes prior to deploying the robot.

OPERATION

WARNING!
- Make sure the robot is off.
- Ensure the charging cable is detached and the charging port is plugged with
the protective cap before the robot is deployed.
1. Bring your robot to the side of your pool. NOTE: Do not place the robot in the pool
corner and against the pool wall as starting location. Unwrap the rope from the float (note
that there are side notches at the top and bottom of the stem, as well as a narrow slot at
the bottom). Allocate sufficient length of the rope that is equivalent to the pool depth plus
an excess of about 0.5 meters (1.6 feet) from the bottom of the float.
First, align and attach the rope to the side notches at the top as you wrap the rope around
the stem (step 1 & 2). Keep wrapping the rope around the top half of the stem until it
reaches the required length (step 3). Pull the rope down to the bottom slot (step 4).
2. With the robot switched off, submerge it in the pool and gently shake it a few times to
facilitate discharge of air. Excess air trapped in the body could result in erratic behavior of
the swivel head (i.e. spinning repeatedly in the pool for a few minutes).
Power indicator
light (Green)
14