Getting Started; Charging The Battery - Kokido DELTA 100 Manuel D'utilisation

GETTING STARTED

Charging The Battery

IMPORTANT NOTE: Fully charge the robot (about 5-6 hrs) before using it for the first time.
WARNING!
 Use only the original external adaptor and charging cable provided.
 Make sure the robot and the charging port are clean and dry before set-up
and charging. (TIPS : Pry open the protective cover and use a cotton bud
to dry the charging port and charging pins)
 The charging pins are waterproof. However, remnants of water in the port
and around the pins could result in natural occurrence of stains (a
byproduct of chemical reaction between water and electric currents).
Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
 Make sure the robot is off by sliding the switch to the OFF position prior to
charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Plug the charging cable of the external adaptor into the charging cable.
Pry open the protective cap. Align and insert the plug of the charging cable
into the charging port at the top of the unit.
WARNING! Be sure not to invert the charging cable and ensure both the
charging cable and charging port are clean and dry before charging them.
TIPS: Use cotton bud to dry the charging port and pins.
3. Connect the external adaptor to the power source. The indicator light on
the external adaptor turns red once the charging begins. The indicator light
on the external adaptor will turn green when the robot is charged.
OFF
ON
11